Weedeater Featherlite

XT 25

From: Cal H.

How do I remove the entire trimmer head from the shaft of the XT25 Featherlight plus?

Hi Cal,
Instead of describing it with words, please find some how to guides videos

FX26SC

From: Noe C.

I think I need a gas tank replacement. I have a gas Weed Eater, inside the the gas container was a loose cylinder metal piece about an inch long. Do I have to replace the tubes? The machine started on choke and half choke but did not stay on when switched to run.

Hi Noe,
The following parts that my be useful for your model, trimmer FX26SC, are: Retainer-Tank #530016445 and Assy-Fuel Tank (including filter, lines, fuel cap) #545104102.

Featherlite XT200

From: Corey R.

The fuel line that’s inside the gas tank to suck the fuel from the tank to the engine has broke and I’m in need of a new gas tank and the fuel lines that are in the tank. I am not able to fit anything in them to fix it. I didn’t see anything on the replacement parts you have available. I have been pleased with your products in the past but was a little disappointed with the durability of the lines. I have had to replace pieces to the primer before. For as little as I use this product, I was hoping it would hold up better as some of your products I’ve used before.
Thank you. Corey R., East Grand Forks, Minnesota.

Hi Corey,
here’s what I found for XT200: Retainer-Fuel Tank is part #530016379, Kit – Line Carb/Purge #530069247, Kit-Line Tank/Purge #530069216, Fuel Tank Assembly (including cap, fuel lines, filter) has part number #545103802 on diagram.

Featherlite

From: Denver S.

I’ve had a featherlite for 13/14 yrs now & it only been in shop once until now. It well starts but I’m thinking on buying a new one. Since my wife is the one who uses it, I brought it for her. Shes only 4′ 11″ small and easy for her to carry. Can u tell me who sells this Featherlite trimmer in Ft. Worth, Texas?

Hi Denver,
I can’t find out official resellers in your hometown, have you thought about buying it online? Most webshops give free shipping for such orders.

Featherlite FX26SC

From: Jeff J.

I can not find out were to set the plug gap to on this model.

Hi Jeff,
Spark plug is part #5 on FX26SC engine parts diagram, see image.

Weed eater Featherlite trimmer

From: Pam P.

We have purchased a used Weedeater Featherlite trimmer and need to know what spool we need to get for this. There was no manual with it. The trimmer doesn’t say anything on the plastic as to the model #. I did see #711334 and 18cc. Serial # 02304NF02926. Can you help me out? Thanks, Pam.

Hi Pam,
You can buy a new spool line without looking at the service manual. Gas trimmers have thicker trimmer line than electric trimmers, so purchasing a trimmer line around 0,100″ would be okay for your 18cc Weedeater.

Extreme FX 26S

From: Kim V.

Where can I purchase a replacement debris shield for FX265? I live in Great Falls, MT. Thanks, Kim.

Hi Kim,
Please find Weedeater Extreme FX 26S has one part matching your search, Kit-Shield Assy part number # 530071795.r

FL20C Lower Shaft and String Head

From: Mike H.

Dear sir,

I purchased my Featherlite FL20C at Walmart in April 2011, have had good luck with it till last week. The case above the string head melted. It was the wierdest thing I ever have seen, I didn’t keep reciept so I imagine your company won’t warranty it but I am hoping you can help me in some way to repair it. I need the lower shaft and new string head where it unscrews in the middle the complete lower part needs replaced, can you write me back with what that will cost me to repair. Thanks.

Hi Mike,
This is not the official company’s website. But we can support you with parts you are looking for. Part “Kit-Lower Shaft” at 15th position has code #545008062, “Accy-TNG IV Cutting Head” is #952701666. Please check it on parts diagram before ordering, diagram is here.

SST25

From: Fontaine W.

How do I remove the original head to switch to a Echo Rapid loader string head?

Hi Fontaine,
here’s a video describing how to remove the trimmer head. A breif description is disconnect the spark plug wire, insert the locking rod into the hole between the shield and the head, rotate the trimmer head.

Weedeater Featherlite FL25 Shaft

From: Harold G.

I want to lock the shaft of the FL25 to place a new head on it but I don’t know what to use to lock the shaft. Can you help me?

Hi Harold,
To lock the shaft on trimmer, you should unplug the spark-plug wire first. Then insert the locking rod in the hole between the shield and head. Lock the shaft by turning the trimmer head.